THE CHECK ENGINE LIGHT.
Every new car now comes with OBD-II - On Board Diagnostics 2.
This is a fault-registering system connected to sensors all over the car, engine, fuel and emissions system.
When the check engine light comes on, it can mean many things. There are something like 4,000 unique OBD2 codes that can be stored. Handheld OBD2 diagnostic tools can be plugged in to the OBD2 port which is normally under the dash on the driver's side. These tools can read out the fault code and/or reset the system to contain no codes. Codes are split into two categories - historical/inactive, and active. The historical codes are lists of things that have been detected in the past but are no longer an issue, whilst the active codes are things that are a problem right now.
Codes are subdivided into B-codes (body), C-codes (chassis) and the biggest list of all - P-codes (powertrain).
THE SERVICE ENGINE LIGHT / MAINT REQuireD LIGHT.
This might indicate "Service", "Service Engine" or "Maint Required". It's an indicator that you're getting close to a scheduled maintenance interval. On some cars it's as simple as counting miles before it comes on, whilst on others it maps engine temperatures, oil temperatures, air temperatures and other indicators of probable stress to tell you when it might be time for new oil or a service.
If you take your car for a service, the garage should reset it for you.
Typically this light will come on when you start your car, and then turn off again as part of the self-check. If it stays on for 10 seconds then turns off, it normally means you're within 500 miles of needing a service. If it flashes for 10 seconds, it normally means you've exceeded a recommended service interval.
THE ELECTRICAL FAULT LIGHT.
This warning light is different in every car but normally it looks like a picture of a battery, similar to the picture on the left here. You'll see it come on and go off when you start your engine as part of the car's self-test, but if this light comes on and stays on, it means the electrical charging system is no longer working properly.
Think of it like a cellphone battery. If the cellphone is plugged into the charger, you can use it indefinitely, but when you disconnect it from the charger, there's a limited amount of time before your battery runs out. It's exactly the same in your car, only bigger. Every car has an alternator - the charger - and a 12v battery used to supply power to the electrical system. If the alternator becomes faulty or the drive belt to it snaps, then it will not be able to do its job. The longer you drive, the more your car will use up the remaining juice in the battery and eventually the engine will die. This almost always requires a new or refurbished alternator.
BRAKE WARNING LIGHT 1
Most cars nowadays have a brake warning light on the dash. Its purpose is to alert you that something is wrong in the braking system somewhere. If it comes on, check your owner's manual to find out its meaning. The brake warning light doesn't have a standard meaning; it could be used for multiple purposes. For example, the same light may be used to show that the hand brake (parking brake for the Americans amongst you) is on. If that's the case and you're driving, you ought to have noticed the smell of burning brake dust by now. The light can also indicate that the fluid in the master cylinder is low. Each manufacturer has a different use and standard for this light. Which is nice. Because it would be such a drag if the same indicator meant the same thing in every vehicle.
BRAKE WARNING LIGHT 2
If you've got an ABS-equipped car, you also have a second light - the ABS light. If it comes on, get it seen to as soon as possible. It means the ABS computer has diagnosed that something is amiss in the system. It could be something as simple as dirt in one of the sensors, or something as costly as an entire ABS unit replacement. Either way, if that light is on, then you, my friend, have got 1970's brakes. It's important to note that this light normally comes on when you start the car and then switches off a few seconds later. If it blinks, throbs, flashes or in any other way draws your attention to itself, then take note. It's not doing that just to please itself. Compared to a steady light, a blinking ABS light normally indicates something more serious. In some cases it could be as bad as "you have no brakes at all."
COOLANT WARNING LIGHT
This is normally the coolant level warning light. If this comes on it means that the level of coolant in your radiator is low and needs topping up. DO NOT OPEN THE RADIATOR CAP WHEN THE ENGINE IS HOT! The coolant system is pressurised and it could easily release pressure and spray you with boiling coolant. Do it when the engine is cold. Top up the system with either a pre-mixed coolant bought from a shop, or with distilled water. Don't use tap water - the mineral deposits in it boil out in the cooling system and calcium gets depositted around the inside of the radiator making it less efficient (which will eventually cause it to fail). It's always best to use pre-mixed coolant, or to mix your own rather than using neat water. The coolant mixture behaves as an antifreeze in winter as well as a corrosion-inhibitor to stop your engine rusting from the inside out.
OIL WARNING LIGHT
Typically this light will come on if your oil pressure is too low. Low oil pressure is serious and if you continue to drive with this light on, eventually your engine will die. Low oil pressure can be caused by a failed oil pump, a blocked oil filter or strainer in the sump, or by low oil levels - for example if your engine is burning oil. Either way, you need to get it fixed, and fast. Low oil pressure is A Bad Thing and your engine won't thank you for leaving this problem untreated.
Call us at (330) 825-2579 and schedule an appointment today. We have all the tools and expertise to keep you on the road!